![]() ![]() Standard outputs and mixed channels: <0.1 V at nominal current 0.5 A Leakage current when the output is switched off High-speed outputs: Output monitoring with 10 µs delay Standard outputs and mixed channels: Output monitoring with 10 ms delay Internal freewheeling diode for switching inductive loads (see section "Switching inductive loads")ĥ to 65535 µs corresponds to 200 kHz to 15 Hz Thermal shutdown in the event of overcurrent or short circuit (see value "Short-circuit peak current") Standard outputs and mixed channels: Source Standard outputs and mixed channels: 0.5 A Standard outputs and mixed channels: Current-sourcing FET ![]() Temperature and analog input enabled: 400 µsįirst-order low-pass filter / cutoff frequency 7 HzĤ standard outputs, 4 high-speed outputs and 4 mixed channels, configuration as input or output using software Resistance measurement with constant current supply for 2-wire connections Third-order low-pass filter / Cutoff frequency 1 kHzĠ to 20 mA = 0.15% (Rev. Protection against wiring with supply voltage ![]() ☑0 V or 0 to 20 mA / 4 to 20 mA, via different terminal connections ![]() High-speed inputs: ≤2 μs, when used as standard inputs: ≤200 μsĭefault 1 ms, configurable between 0 and 25 ms in 0.1 ms incrementsĢx 250 kHz event counting, 2x AB counter, ABR incremental encoder, direction/frequency, period measurement, gate measurement, differential time measurement, edge counters, edge times Standard inputs and mixed channels: ≤200 μs 100 m between 2 stations (segment length)ġ4 standard inputs, 4 high-speed inputs and 4 mixed channels, configuration as input or output using software 20 mĬonnection via 16-pin terminal block X20TB1F Shielded lines must be used for all high-speed digital inputs/outputs, line length: Max. Power consumption for X2X Link power supplyĪdditional power dissipation caused by actuators (resistive) Power consumption without interface module and USB CPU function, Ethernet, POWERLINK, RS232, CAN bus, CAN bus terminating resistor, PLC power supply, I/O power supply, I/O function per channelĭigital outputs: Yes, using LED status indicator and software (output error status)Īnalog inputs: Yes, using LED status indicator and software ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |